The OE error code on an LG washing machine indicates a drainage issue. This can be caused by a clogged drain, kinks in the drain hose, a faulty pump, or a blocked or broken pump filter. Here’s a step-by-step guide to troubleshooting and correcting this problem.

Step 1: Check the Drain Hose

The first possible source of the issue could be a kinked or clogged drain hose, which would stop the washer from draining properly. To check this :

  1. Turn off and unplug your washing machine.
  2. Locate the drain hose at the back of the washer. This is typically a flexible, slightly larger hose.
  3. Disconnect the hose and inspect it for any kinks. If you notice any, straighten them out.
  4. Visualize or probe inside for blockages. It can also be cleaned by flushing water through it.

Step 2: Inspect the Drain Pump Filter

The problem may also be a blocked or broken pump filter. To check the pump filter:

  1. Locate the access cover for the drain pump filter. It’s typically on the front bottom of the washer.
  2. Open the cover and unscrew the filter counter-clockwise to remove it.
  3. Inspect and clean the filter. If it’s broken, it should be replaced.

Step 3: Examine the Drain Pump

If the hose and filter are in good condition, the drain pump itself could be the problem. The pump could be faulty or have a loose connection. Check the pump:

  1. Remove the back panel of the washer to expose the pump.
  2. Inspect it for any visible damage or loose connections.
  3. If you see damage or believe the pump might be faulty, it’s best to call a technician for a pump replacement.

Step 4: Restart your Washer

Now that you’ve addressed the possible causes of the OE error, restart your machine:

  1. Reconnect any hoses or filters that were removed and secure the back panel.
  2. Plug in and switch on your machine.
  3. Run a short cycle without any clothes to check whether the error has cleared.

Conclusion

Fixing the OE error on an LG washing machine may be a simple case of removing a clog or a kink, or it could involve replacing parts. If you’re not comfortable doing these steps yourself, or if the error continues after these steps, it’s time to contact a professional for further inspection and repairs.

Categories: Fault Codes

0 Comments

Leave a Reply

Avatar placeholder

Your email address will not be published. Required fields are marked *